Telrad Pulser Kit for Telrad Finder

Telrad Pulser Kit voor Telrad zoeker

The Telrad Pulser improves contrast by pulsing the reticle image on and off, thus aiding in the location of faint objects. It will also greatly increase the battery life for your Telrad. Following the simple instructions you can easily install the pulser in a short time. Once installed, the original control knob still controls the power and brightness, and the new control knob will control the pulse speed of the reticle image. You can vary the pulse frequency from very slow to having the reticle image constantly on.

The reticle illumination source of the Telrad sight is a red Light Emitting Diode (LED) powered by two "AA" batteries. The LED is controlled by means of a potentiometer at the right rear corner of the Telrad, rotating the dial varies the intensity of the LED. While this arrangement permits the observer to adjust the brightness of the light source, this is either a continuous on or off arrangement.